TS/MP Management Programming Manual (G06.24+, H06.03+)

Pathway Subsystem Control Commands
NonStop TS/MP Management Programming Manual—540082-001
8-17
STOP PM
•
To implement the equivalent of the PATHCOM SHUTDOWN ! command, add an
ABORT TERM command for all TERMs (specifying continuation) after the STOP
TERM command in the previous sequence.
•
To implement the equivalent of the WAIT option for the PATHCOM SHUTDOWN
command, reissue the STOP command sequence repeatedly until ZSPI-TKN-
RETCODE returns no error.
STOP PM
Use the STOP PM command to stop the PATHMON process pair; the Pathway
subsystem must be currently in the process of shutting down (ZPATHWAYSTATE is
set to ZPWY-VAL-SHUTDOWN).
Continuation
You cannot use continuation with this command.
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-29. For descriptions of tokens and fields, see
Section 4, SPI and EMS Standard Definitions through Section 7, ZPWY-MAP-
Definitions.
Tokens in Response Buffer
For STOP PM, the common error value for ZSPI-TKN-RETCODE is:
1045 (ZPWY-ERR-PM-STATEMISMATCH)
indicates the Pathway subsystem is not in the SHUTDOWN state.
For descriptions of all error-token values and their associated error lists, see
Section 10, Event Management.
Command
ZPWY-CMD-STOP
Object Type
ZPWY-OBJ-PM
Tokens in Response Buffer
ZSPI-TKN-RETCODE token-type ZPSI-TYP-INT.