TS/MP Management Programming Manual (G06.24+, H06.03+)

Server Class Commands

NonStop TS/MP Management Programming Manual—540082-001

9-16

ALTER SCASSIGN

Use the ALTER SCASSIGN command to change the attributes of a server ASSIGN

message. The attributes are the same as those for the ASSIGN parameter of the

PATHCOM SET SERVER command. All server processes in the server class must be

in the STOPPED state to use this command.

Continuation

You cannot use continuation with this command to alter all server ASSIGN messages;

you must explicitly alter each ASSIGN message by name.

Command Syntax

For tokens that may be present in the command and response buffers but are not

listed, see Unlisted Tokens on page 3-29. For descriptions of tokens and fields, see

Section 4, SPI and EMS Standard Definitions through Section 7, ZPWY-MAP-

Definitions.

Considerations

•

For ALTER commands, the values for tokens and fields omitted from the command

buffer remain unchanged.

Reset values for each field are predefined. These values are described in

Section 3, SPI Programming Considerations. To reset ZGUARDIANFILE using the

TACL program, you must use the #SETBYTES built-in function. For more

information, see the SPI Programming Manual.

•

To specify node independence for server class attributes, specify \* for node

names or omit node names and set ZNODEINDEPENDENT to ON in the START

PATHWAY command.

Command

ZPWY-CMD-ALTER

Object Type

ZPWY-OBJ-SCASSIGN

Tokens in Command Buffer

ZPWY-MAP-SEL-SCASSIGN token-type ZPWY-DDL-SEL-SCASSIGN.

ZPWY-MAP-DEF-SCASSIGN token-type ZPWY-DDL-DEF-SCASSIGN.

Tokens in Response Buffer

ZPWY-MAP-SEL-SCASSIGN token-type ZPWY-DDL-SEL-SCASSIGN.