TS/MP Management Programming Manual (G06.24+, H06.03+)

Server Class Commands
NonStop TS/MP Management Programming Manual—540082-001
9-18
ALTER SCPARAM
ALTER SCPARAM
Use the ALTER SCPARAM command to change the attributes of a server PARAM
message. The attributes are the same as those specified for the PARAM parameter of
the PATHCOM SET SERVER command. All server processes in the server class must
be in the STOPPED state to use this command.
Continuation
You cannot use continuation with this command to alter all parameters; you must
explicitly alter each parameter by name.
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-29. For descriptions of tokens and fields, see
Section 4, SPI and EMS Standard Definitions through Section 7, ZPWY-MAP-
Definitions.
Considerations
•
For ALTER commands, the values for tokens and fields omitted from the command
buffer remain unchanged.
Reset values for each field are predefined. These values are described in
Section 3, SPI Programming Considerations.
•
To perform the equivalent of the PATHCOM ALTER SERVER, RESET PARAM
command, use the DELETE SCPARAM command.
Command
ZPWY-CMD-ALTER
Object Type
ZPWY-OBJ-SCPARAM
Tokens in Command Buffer
ZPWY-MAP-SEL-SCPARAM token-type ZPWY-DDL-SEL-SCPARAM.
!r
ZPWY-MAP-DEF-SCPARAM token-type ZPWY-DDL-DEF-SCPARAM.
!r
Tokens in Response Buffer
ZPWY-MAP-SEL-SCPARAM token-type ZPWY-DDL-SEL-SCPARAM.