TS/MP Management Programming Manual (G06.24+, H06.03+)

Server Class Commands
NonStop TS/MP Management Programming Manual—540082-001
9-19
ALTER SCPROCESS
ALTER SCPROCESS
Use the ALTER SCPROCESS command to change the attributes of a server process.
The attributes are the same as those specified with PROCESS parameter of the
PATHCOM SET SERVER command. All server processes in the server class must be
in the STOPPED state to use this command.
Continuation
You cannot use continuation with this command to alter all server process names; you
must explicitly alter each server process name.
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-29. For descriptions of tokens and fields, see
Section 4, SPI and EMS Standard Definitions through Section 7, ZPWY-MAP-
Definitions.
Considerations
•
For ALTER commands, the values for tokens and fields omitted from the command
buffer remain unchanged.
Reset values for each field are predefined. These values are described in
Section 3, SPI Programming Considerations. To reset ZGUARDIANSWAP or
ZHOMETERM using the TACL program, you must use the #SETBYTES built-in
function. For more information, see the SPI Programming Manual.
•
An associative server is configured with the ZASSOCIATIVE field in
ZPWY-DDL-DEF-SCPROCESS set to ZPWY-VAL-ON.
Command
ZPWY-CMD-ALTER
Object Type
ZPWY-OBJ-SCPROCESS
Tokens in Command Buffer
ZPWY-MAP-SEL-SCPROCESS token-type ZPWY-DDL-SEL-SCPROCESS.
!r
ZPWY-MAP-DEF-SCPROCESS token-type ZPWY-DDL-DEF-SCPROCESS.
!r
Tokens in Response Buffer
ZPWY-MAP-SEL-SCPROCESS token-type ZPWY-DDL-SEL-SCPROCESS.