TS/MP Management Programming Manual (G06.24+, H06.03+)

Server Class Commands
NonStop TS/MP Management Programming Manual—540082-001
9-20
ALTER SCSTARTUP
When changing the definition of an associative server, make sure you make the
changes everywhere the associative server is defined. Otherwise, you cannot be
sure that the new definition will be implemented or permanent. For more
information on associative servers, see Server Objects on page 3-26.
•
To specify node independence for server class attributes, specify \* for node
names or omit node names and set ZNODEINDEPENDENT to ON in the START
PATHWAY command.
•
To perform the equivalent of the PATHCOM ALTER SERVER, RESET PROCESS
command, use the DELETE SCPROCESS command.
ALTER SCSTARTUP
Use the ALTER SCSTARTUP command to change a server startup string. The startup
string is the same as the STARTUP string parameter of the PATHCOM SET
SERVER command. All server processes in the server class must be in the STOPPED
state to use this command.
Continuation
You cannot use continuation with this command to alter all startup strings; you must
explicitly alter the startup string for each server class name.
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-29. For descriptions of tokens and fields, see
Section 4, SPI and EMS Standard Definitions through Section 7, ZPWY-MAP-
Definitions.
Command
ZPWY-CMD-ALTER
Object Type
ZPWY-OBJ-SCSTARTUP
Tokens in Command Buffer
ZPWY-MAP-SEL-SCSTARTUP token-type ZPWY-DDL-SEL-SCSTARTUP.
!r
ZPWY-MAP-DEF-SCSTARTUP token-type ZPWY-DDL-DEF-SCSTARTUP.
!r
Tokens in Response Buffer
ZPWY-MAP-SEL-SCSTARTUP token-type ZPWY-DDL-SEL-SCSTARTUP.