TS/MP Management Programming Manual (G06.24+, H06.03+)

Introduction
NonStop TS/MP Management Programming Manual—540082-001
1-5
Management Interfaces
Figure 1-2 illustrates a Pathway subsystem that uses the SPI and EMS procedures for
subsystem control and event management.
Management Interfaces
There are two ways to configure and control TS/MP: either interactively by entering
PATHCOM commands at a terminal or programmatically by writing a management
application program. Both of these methods allow you to send commands and
instructions to PATHMON, the process that monitors your subsystem and directs its
activities. Figure 1-3 on page 1-6 illustrates these two interfaces and their relationship
to a PATHMON process.
Figure 1-2. TS/MP and DSM
PATHMON
Management
Application
Event
Collector
Event
Distributor
Event
Log
Command
Message
Response
Message
GETEVENT
Command
Message
GETEVENT
Response
Message
VST003.vsd