TS/MP Management Programming Manual (G06.24+, H06.03+)

PATHMON Error Messages
NonStop TS/MP Management Programming Manual—540082-001
12-22
Error-Message Range 1000 Through 1999
1026: ZPWY-ERR-PM-BADMSG
A message received does not conform to the PATHMON request protocol. This error
can be caused by running incompatible versions of PATHCOM, PATHMON, or
PATHTCP. The message was received from the process running under the specified
user ID.
This error does not appear as an error list; it appears only in the RETCODE token in
response to a command that is using continuation.
Effect. The PATHMON process rejects the request.
Recovery. Contact your HP support representative.
1031: ZPWY-ERR-PM-MISSINGPARAM
A required Pathway configuration parameter is not defined.
For a description of tokens that are present in this event message but are not listed or
described below, see Section 10, Event Management.
Token Description
ZSPI-TKN-ERROR
contains ZPWY-ERR-PM-MISSINGPARAM.
Effect. The command fails.
Recovery. Define the required parameter.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.
ZPWY-TKN-REQCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-REQOBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-REQnnnNAME token-type ZPWY-TYP-nnnNAME.
ZPWY-TKN-ERRCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-ERROBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-nnnNAME token-type ZSPI-TYP-nnnNAME.
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.