TS/MP Management Programming Manual (G06.24+, H06.03+)

Configuration Limits and Defaults
NonStop TS/MP Management Programming Manual—540082-001
A-3
BACKUPCPU ZCPU
ZCPUPAIR
Values: 0 through 15
Value should be a CPU number
that is greater than plus or minus
1 from the primary CPU.
Default: Depends on command
COUNT N.A. Values: 0 through 65,536
Default: 1
CPU
CPUS
ZCPU
ZCPUPAIR
Values: For CPU pairs, maximum of 16
pairs, 0 through 15.
Backup CPU numbers need not
be unique.
For a sequence of single CPUs,
maximum of 16 CPUs, 0 through
15. Each CPU must be unique.
Default: Determined by PATHMON (all
available CPUs are used).
CREATEDELAY ZCREATEDELAY Values: HRS | MINS | SECS
0 through 16,383 SECS, or
0 through 1092 MINS, or
0 through 18 HRS
The time set for this parameter
may be added to the response
time for all transactions; therefore,
the value should be small.
Default: 1 MINS
CWD ZPWY-TKN-
DEFSCCWD
Values: Absolute OSS pathname of the
current working directory.
Default: None
DEBUG ZDEBUG Values: ON | OFF
Default: OFF
DELETEDELAY ZDELETEDELAY Values: HRS | MINS | SECS
0 through 16,383 SECS, or
0 through 1092 MINS, or
0 through 18 HRS
Default: 10 MINS
Table A-2. Limits and Defaults for Parameters (page 2 of 10)
PATHCOM
Parameter* SPI Token/Field** Value Limits and Defaults