TS/MP Supplement for Limits Relief (G06.26+)

1. Stop the Pathsend
requesters.
See the TS/MP System Management Manual.
2. Stop the ACS
subsystem.
Use the STOP command. For detailed information about this command,
see STOP in Chapter 7. For example:
STOP ACS $ZACS, FORCED
3. Verify the ACS
subsystem is
stopped.
Use the STATUS command. For detailed information about this
command, see STATUS in Chapter 7. For example:
STATUS ACS $ZACS, DETAIL
4. Modify the
subsystem
configuration.
When the ACS subsystem is stopped, use the ALTER command. For
detailed information about this command, see ALTER in Chapter 7. For
example:
ALTER ACS $ZACS, &
LOG1 $VOL1.LOGFILES.LOG10:"EMS":"ALL"
5. Start the ACS
subsystem.
Use the START command. For detailed information about this
command, see START in Chapter 7. For example:
START ACS $ZACS
The ACS subsystem functions are available again, according to the new (and permanent) values
you specified.
Displaying Information
Displaying ACS subsystem configuration
Use the INFO command to display the configuration values set by the ADD and ALTER
commands. For detailed information about this command, see INFO in Chapter 7. For example:
INFO ACS $ZACS, DETAIL
Displaying ACS domain coordinator ($ZACS) name
Use the NAMES command to display the name of the domain coordinator process. For detailed
information about this command, see NAMES in Chapter 7. For example:
NAMES ACS $ZACS
Displaying ACS subsystem and processor status
Use the STATUS command to display the current, operational status of the ACS subsystem. For
detailed information about this command, see STATUS in Chapter 7. For example: