TS/MP Supplement for Limits Relief (G06.26+)

3. Start the ACS Subsystem
1. Start the ACS subsystem.
Use the SCF START command. For detailed
information about this command, see START in
Chapter 7. For example:
START ACS $ZACS
2. Verify the ACS subsystem is started.
Use the SCF STATUS command. For detailed
information about this command, see STATUS in
Chapter 7. For example:
STATUS ACS $ZACS, DETAIL
4. Restart the Pathsend Requesters
For information on starting Pathsend requesters, see the TS/MP System Management Manual.
Stopping the Subsystem
If you are stopping the subsystem to change the configuration, you need to perform Step 1 and
Step 2 only. If you are preparing to remove TS/MP 2.1, you need to perform all the following
steps.
1. Stop the Pathsend Requesters
Stop the Pathsend requesters. See the TS/MP System Management Manual.
2. Stop the ACS Subsystem
1. Stop the ACS subsystem.
Use the SCF STOP command. For detailed
information about this command, see STOP in
Chapter 7. For example:
STOP ACS $ZACS, FORCED
2. Verify the ACS subsystem is stopped.
Use the SCF STATUS command. For detailed
information about this command, see STATUS in
Chapter 7. For example:
STATUS ACS $ZACS, DETAIL