TS/MP Supplement for Limits Relief (G06.26+)

3. Stop $ZACS
1. Check whether $ZACS is
stopped.
Use the SCF STATUS PROCESS command. For example:
STATUS PROCESS $ZZKRN.#ZACS, DETAIL
2. If $ZACS is running,
abort it.
Use the SCF ABORT command interactively or in an OBEY file,
as follows:
ASSUME PROCESS $ZZKRN
ABORT #ZACS
The ABORT PROCESS command stops $ZACS but does not
delete the process configuration. In other words, you can use the
SCF START command to start $ZACS again.
3. Verify that $ZACS is
stopped.
Use the SCF STATUS command as described in Step 1.
4. Delete the $ZACS Process Configuration
Delete the ACS domain coordinator process
($ZACS).
This step also deletes the ACS subsystem
configuration file (BCINI).
Use the SCF DELETE PROCESS command
interactively or in an OBEY file, as follows:
ASSUME PROCESS $ZZKRN
DELETE #ZACS
The DELETE PROCESS command removes
the $ZACS configuration. Therefore, before
you can start $ZACS again, you must use the
SCF ADD command to add the ACS
subsystem.
Prev Up Next
Chapter 5. Installing and
Configuring
Home
Chapter 7. SCF Command
Reference for the ACS Subsystem
528626.001
Legal Notices