TS/MP Supplement for Limits Relief (G06.26+)

Chapter 9. SCF Error Messages
Prev Next
Chapter 9. SCF Error Messages
If You Have to Call Your Service Provider
SCF Error Messages
This chapter describes the SCF error messages returned by the ACS subsystem interface to
SCF. Refer to the SCF Reference Manual for G-Series RVUs for the list of SCF messages for all
subsystems.
If You Have to Call Your Service Provider
If the recovery for an error message indicates that you should contact your service provider, you
should be prepared to supply a log file with the following information. (If the error caused SCF
to terminate, start SCF again.)
Use the LOG command to collect the following displays into a single file. For example:
LOG PROBLEM !
1.
Use the LISTPM command to collect information about the product versions of the SCF
components, a list of the product modules on your system, and information about any
product modules running when the error occurred. For example:
LISTPM
2.
Use the ENV command to collect information about the SCF environment that was
present when the error occurred. For example:
ENV
If the error caused SCF to terminate, specify again any environmental characteristics that
were present when the error occurred.
3.
Use the DETAIL CMDBUFFER and DETAIL RSPBUFFER commands to capture the
contents of the SPI buffer. For example:
DETAIL CMDBUFFER ON DETAIL RSPBUFFER ON
4.
Reproduce the sequence of commands that produced the SCF error.5.
Close the log file:
LOG
6.