TS/MP System Management Manual (G06.24+, H06.03+)

NonStop TS/MP System Management Manual—541819-001
11-1
11
PATHMON Environment Control
Commands
This section describes the PATHCOM commands that control the PATHMON process
and the PATHMON environment as a whole; the commands are listed in alphabetic
order. The PATHMON environment control commands are as follows:
These commands define the PATHMON configuration and control basic PATHMON
environment operations. With these commands you can do:
•
Start and stop PATHMON environment operations
•
Designate and change the processor where the PATHMON backup process runs
•
Set the limits for the number of PATHMON-controlled objects
•
Specify the PATHMON process logging requirements
•
Display PATHMON object attributes and status information
The only PATHCOM command for the LINKMON object is STATUS LINKMON. For
more information about LINKMON processes, see the Introduction to NonStop
Transaction Processing . For a list of PATHCOM commands that allow you to perform
functions related to LINKMON processes, see Section 8, Overview of PATHCOM For
detailed information about LINKMON processes and their use with Pathsend
requesters, see the TS/MP Pathsend and Server Programming Manual .
To Perform These Tasks… Use These PATHCOM Commands…
Define attribute values SET PATHWAY
SET PATHMON
Change attribute values CONTROL PATHMON
Change process states START PATHWAY
STOP PATHMON
SHUTDOWN
SHUTDOWN2
Obtain information about INFO PATHWAY
INFO PATHMON
STATUS PATHWAY
STATUS PATHMON
STATUS LINKMON
Perform other management tasks LOG1
LOG2
PRIMARY PATHMON
SWITCH PATHMON