TS/MP System Management Manual (G06.24+, H06.03+)

PATHMON Environment Control Commands
NonStop TS/MP System Management Manual—541819-001
11-31
STATUS PATHWAY Command
STATUS PATHWAY Command
Use the STATUS PATHWAY command to display the number of PATHMON-controlled
objects that are in each possible state. This command provides an overview of the
Pathway environment.
You can also use the STATUS PATHWAY command with the SHUTDOWN2
command to monitor the progress of a Pathway environment shutdown.
OUT list-file
directs output to the file that you specify; this could be a DEFINE name. If you omit
this option, the PATHMON process writes the output to the PATHCOM list file; this
is typically the home terminal.
COUNT number
determines the number of times that the status screen is displayed until the Break
key is used, or until the Pathway environment is shut downwhichever occurs
first. The default count is 1.
INTERVAL number HRS | MINS | SECS
determines the delay between the status displays. The delay is based on the
value specified by number in hours, minutes, or seconds. The default is no delay
between STATUS PATHWAY displays.
The STATUS PATHWAY display formats are described in this discussion. For
information about the Pathway/iTS objects that appear in this display (EXTERNAL
TCPS, TCPS, and TERMS), see the Pathway/iTS System Management Manual.
Display Format  Running
Example 11-3 on page 11-32 shows the format of the display returned by the STATUS
PATHWAY command while the system is running.
STATUS [ / OUT list-file /] PATHWAY , option [ , option] ...
option is:
COUNT number
INTERVAL number { HRS | MINS | SECS }