TS/MP System Management Manual (G06.24+, H06.03+)

NonStop TS/MP System Management Manual—541819-001
12-1
12 SERVER Commands
This section describes the PATHCOM commands that define and control SERVER
objects; the commands are listed in alphabetic order. The server class commands are
as follows:
With these commands you can:
•
Set and modify server class attributes
•
Add and delete server classes
•
Start and stop server processes
•
Display server attribute and status information
•
Control server communication
ADD SERVER Command
Use the ADD SERVER command to enter the name and description of a server class
into the PATHMON configuration file. Use this command after defining a server class
with the SET SERVER command.
server-class
specifies the name of a server class. A SERVER object name can be from 1 to 15
alphanumeric or hyphen characters and must start with a letter, be unique within
the Pathway environment, and not be a Pathway reserved word.
To Perform these Tasks… Use These PATHCOM Commands…
Define and remove server classes SET SERVER
ADD SERVER
DELETE SERVER
Control servers in server class START SERVER
STOP SERVER
Change server class attributes ALTER SERVER
RESET SERVER
Control requests to servers FREEZE SERVER
THAW SERVER
Obtain information about INFO SERVER
SHOW SERVER
STATS SERVER
STATUS SERVER
Note. Information in this section about the interaction between TCPs and server attributes
applies to your environment only if you are using the Pathway/iTS product.
ADD SERVER server-class [ , server-attribute ]...