TS/MP System Management Manual (G06.24+, H06.03+)

SERVER Commands
NonStop TS/MP System Management Manual—541819-001
12-4
ALTER SERVER Command
Consideration
For information on altering associative servers, see the discussion of associative
servers in Section 5, Maintaining a PATHMON Environment.
Errors
This table lists the most common error that can occur during the processing of the
ALTER SERVER command:
Examples
These commands change various attribute values for the specified server classes:
ALTER SERVER CLASS-1, PRI 10
ALTER CLASS-2, RESET (TMF, MAXLINKS)
ALTER SERVER CLASS-3, DELETE PARAM SWITCH-1
ALTER SERVER CLASS-4, DEFINE =EMP, CLASS MAP, FILE
$D.APPL.EMP
These commands produce the same result:
ALTER SERVER CLASS-1, RESET PROCESS $ABC
ALTER SERVER CLASS-1, DELETE PROCESS $ABC
This Message… Is Displayed When…
*1102* TOO MANY SERVER ENTRIES You have tried to alter a server class
configuration but you have already added the
maximum number of SERVER object entries
(that is, 4095) supported by the PATHMON
process.
The command failed because the PATHMON
process executes the ALTER SERVER
command by creating a new server class entry
with the altered values before deleting the
existing server class entry. When the maximum
number of server class entries already exists,
the PATHMON process does not have the
space to create a new server class.
To avoid this problem, define and add the
maximum number of SERVER entries allowed
minus 1 (that is, 4094 SERVERs).