TS/MP System Management Manual (G06.24+, H06.03+)

SERVER Commands
NonStop TS/MP System Management Manual—541819-001
12-27
SET SERVER Command
If you omit this attribute, the default is OFF.
CPUS primary:backup | cpu
specifies the primary and backup processors in which the server process
runs or a list of individual CPUs.
When this attribute is included as part of the PROCESS attribute
specification, the PATHMON process uses the CPUs specified for the
server process. The CPUs specified for the server process do not need to
match the CPUs specified for the server class.
If you omit this attribute, the PATHMON process assigns all CPUs. See the
description of the CPUS attribute earlier in this command.
DEBUG { ON | OFF }
determines whether the server process enters debug mode upon startup.
If you omit this attribute, the default is ON.
GUARDIAN-SWAP $volume
specifies the Guardian name of the disk volume for the swap file formerly
used by the operating system for memory swaps of the server data area.
Allocation of this swap file is now handled by the Kernel Managed Swap
Facility (KMSF) on behalf of the PATHMON process, and any value
specified for this parameter is not used. However, if you specify a value for
this parameter, it must represent an existing device, or an error occurs.
If you allow this parameter to default, recall that defaults for Guardian file
name expansion are based on values you specify for the CMDVOL
command and the SET PATHWAY NODEINDEPENDENT attribute. See
the command descriptions in CMDVOL Command on page 10-3 and SET
PATHWAY Command on page 11-12.
HOMETERM file-name
specifies the name of the home terminal for the server process. See the
description of the HOMETERM attribute earlier in this command.
ON allows the PATHMON process to grant links to the server
process, even if a server by the same name already exists. A
START SERVER command is successful.
OFF does not allow the PATHMON process to grant links to the server
process if a server by the same name already exists. A START
SERVER command fails.
ON directs the server process to enter debug mode.
OFF directs the server process not to enter debug
mode.