TS/MP System Management Manual (G06.24+, H06.03+)

PATHMON Messages (Numbers 1000-1999)
NonStop TS/MP System Management Manual—541819-001
13-12
PATHMON Messages
Effect. The requesting TCP or LINKMON process is not linked to the server class.
Recovery. Increase the value of the MAXSERVERS, MAXLINKS, or LINKDEPTH
attribute in the server class definition. (It is not recommended that you set
LINKDEPTH higher than 1 for servers other than communications-based servers, such
as HLS servers.)
1035
Cause. The specified entry does not exist. Either the wrong object name was used or
the desired object does not exist.
Effect. The operation fails.
Recovery. Correct the object name or add the object to the PATHMON configuration
file.
1036
Cause. There is an invalid system name in the definition of the indicated object.
Effect. The operation fails.
Recovery. Use an ALTER command to correct the system name in the object
definition.
1037
Cause. An extraneous entry was deleted from the PATHMON configuration file during
a cool start. These entry types are deleted:
•
Temporary TERM entries that were created for a RUN PROGRAM request. This
entry type only applies is you are running the Pathway/iTS product.
•
Old copies of entries that were made obsolete as a result of an ALTER command
•
Temporary server process entries that were named by the system
Effect. None
Recovery. Informational message only; no corrective action is needed.
*1035* object-name, NO SUCH ENTRY
*1036* object-name, NO SUCH SYSTEM
*1037* object-name, PARTIAL ENTRY DELETED (%internal-id)