TS/MP System Management Manual (G06.24+, H06.03+)

PATHMON Messages (Numbers 1000-1999)
NonStop TS/MP System Management Manual—541819-001
13-23
PATHMON Messages
Effect. The PATHMON process terminates.
If the DUMP attribute is enabled, the PATHMON process creates a dump file before
terminating.
Recovery. Contact your HP representative and provide all relevant information as
follows:
•
Descriptions of the problem and accompanying symptoms
•
Details from the message(s) generated
•
Your PATHMON configuration file and the PATHMON process version
•
A description of the application task that was in progress when the error was
encountered
•
Supporting documentation such as Event Management Service (EMS) logs, trace
files, and dump files, if applicable
If your local operating procedures require contacting the Global Customer Support
Center (GCSC), supply your system number and the numbers and versions of all
related products as well.
1079
Cause. A START SERVER command failed because the SET SERVER NUMSTATIC
attribute is set to 0.
Effect. The PATHMON process cannot start a server process until it receives a
request from a the LINKMON process or a TCP.
Recovery. Define the SET SERVER NUMSTATIC attribute with a value from 1
through 4094.
1080
Cause. A software or hardware failure resulted in a trap. This is an internal error.
These values give the process environment at the time the PATHMON process failed:
*1079* NO STATIC SERVERS DEFINED
*1080* PATHMON, TRAP: T=%trap S=%s-reg P=%p-reg E=%e-reg
L=%l-reg
%trap-no is the number of the trap for use with DEBUG
%s-reg is the stack register