TS/MP System Management Manual (G06.24+, H06.03+)

PATHMON Messages (Numbers 1000-1999)
NonStop TS/MP System Management Manual—541819-001
13-25
PATHMON Messages
1085
Cause. You attempted to set the HIGHPIN attribute to ON for the PATHMON process.
Effect. The PATHMON process cannot run.
Recovery. Reset the HIGHPIN attribute to OFF and reissue the START command.
1086
Cause. The TYPE parameter of the RUN PROGRAM command is undefined or
mismatched, or the PROGRAM definition has not been added.
Effect. The operation fails.
Recovery. Supply a value for the RUN PROGRAM TYPE parameter.
1087
Cause. The terminal running the program was stopped by the STOP TERM
command.
Effect. The terminal’s operation stops.
Recovery. Informational message only; no corrective action is needed.
1088
Cause. The terminal running the program was aborted by the ABORT TERM
command.
Effect. The terminal’s operation terminates.
Recovery. Informational message only; no corrective action is needed.
1089
Cause. The terminal running the program encountered an error that caused the
terminal to suspend.
*1085* PATHMON MUST NOT RUN WITH HIGHPIN SET
*1086* TERM TYPE NOT DEFINED FOR PROGRAM
*1087* TERMINAL STOPPED BY OPERATOR
*1088* TERMINAL ABORTED BY OPERATOR
*1089* TERMINAL ABORTED BECAUSE OF ERROR