TS/MP System Management Manual (G06.24+, H06.03+)

PATHMON Messages (Numbers 1000-1999)
NonStop TS/MP System Management Manual—541819-001
13-29
PATHMON Messages
Recovery. Increase the value of the MAXSTARTUPS attribute and reissue the ADD
SERVER or ALTER SERVER command.
1105
Cause. The number of ASSIGN definitions has reached the maximum value specified
for the MAXASSIGNS attribute of the SET PATHWAY command.
Effect. The ADD SERVER or ALTER SERVER command fails.
Recovery. Increase the value of the MAXASSIGNS attribute and reissue the ADD
SERVER or ALTER SERVER command.
1106
Cause. The number of PARAM definitions has reached the maximum specified for the
MAXPARAMS attribute of the SET PATHWAY command.
Effect. The ADD SERVER or ALTER SERVER command fails.
Recovery. Increase the value of the MAXPARAMS attribute and reissue the ADD
SERVER or ALTER SERVER command.
1107
Cause. The number of tell messages issued has reached the maximum specified for
the MAXTELLS attribute of the SET PATHWAY command, or the value defined for the
MAXTELLS attribute is too large.
Effect. The tell message requests fail.
Recovery. Increase or decrease the value of the MAXTELLS attribute, depending on
the cause of the error.
1108
Cause. The number of PROGRAM descriptions has reached the maximum value
specified for the MAXPROGRAMS attribute of the SET PATHWAY command.
Effect. The ADD PROGRAM command fails.
*1105* SERVER server-class, TOO MANY ASSIGN ENTRIES
*1106* SERVER server-class, TOO MANY PARAM ENTRIES
*1107* TOO MANY TELL MESSAGE ENTRIES
*1108* PROGRAM program-unit-name, TOO MANY PROGRAM ENTRIES