TS/MP System Management Manual (G06.24+, H06.03+)

NonStop TS/MP System Management Manual—541819-001
16-1
16
LINKMON Log Messages
This section describes, in alphabetic order, the log messages that a LINKMON process
can write to the system log, $0, during LINKMON initialization.
General Information
The LINKMON process in a processor does not begin initialization until it receives a
SERVERCLASS_SEND_ call from a Pathsend process executing in its processor. If
an error occurs during LINKMON initialization, the LINKMON process:
•
Returns an error to the application (Pathsend error 947, file-system error).
•
Writes a message to $0 indicating the reason for failure.
•
Waits ten seconds before processing any additional SERVERCLASS_SEND_
calls, so that subsequent sends to the uninitialized LINKMON process do not flood
$0.
Each subsequent SERVERCLASS_SEND_ call in this processor causes the
LINKMON process to reattempt initialization; once the error condition is corrected, the
LINKMON process can complete initialization.
The LINKMON log messages are type 512 event messages that you can display from
$0 with an EMS printing distributor or ViewPoint. For more information, see the EMS
Manual or the ViewPoint Manual . Although type 512 messages are sent to the EMS
collector $0, they are not included in the Operator Messages Manual ; that manual
contains only numbered messages.
Some LINKMON messages have file-system errors associated with them. For a
description of file-system errors, see the Guardian Procedure Errors and Messages
Manual .
All LINKMON log messages have the following format:
LINKMON ( LINKMON-process-name | CPU,PIN ) - message-text
where message-text is one of the messages described in this section.
LINKMON Log Messages
These messages are generated by LINKMON processes:
Cause. The LINKMON process was unable to obtain sufficient memory to continue
running.
Failed to get length bytes of extended memory