TS/MP System Management Manual (G06.24+, H06.03+)

LINKMON Log Messages
NonStop TS/MP System Management Manual—541819-001
16-2
LINKMON Log Messages
Effect. The LINKMON process is unable to process SERVERCLASS_SEND_ calls.
This message is always followed by an EMS message that describes why the
LINKMON process could not obtain enough memory.
Recovery. Recovery depends on the error that occurs. For example, if the next
message is “SEGMENT_ALLOCATE_ error 1 (error detail 43) on swap file
$SYSTEM.ZLINKMON.ZZLM04,” you must make additional disk space available
before the LINKMON process can initialize itself. Each subsequent
SERVERCLASS_SEND_ call in this processor causes the LINKMON process to
reattempt initialization; once the condition is corrected, the LINKMON process can
complete initialization.
Cause. The LINKMON process is operational.
Effect. The LINKMON process is available for processing SERVERCLASS_SEND_
calls from requesters in its processor.
Recovery. Informational message only; no corrective action is needed.
Cause. You attempted to start a LINKMON process with a RUN command.
Effect. The LINKMON process terminates processing.
Recovery. There is no way to recover from this error condition; you cannot start a
LINKMON process with a RUN command.
Cause. An error occurred when the LINKMON process attempted to create an
extended memory segment. If SEGMENT_ALLOCATE_ returned error 1, 2, 3, or 14,
the message includes error detail information.
Effect. The LINKMON process is unable to process SERVERCLASS_SEND_ calls.
Recovery. Recovery depends on the file error that occurs. For example, error 1 with
error detail FENODISCSPACE (43) indicates that the specified disk does not contain
enough free space for the swap file. You must make additional disk space available
before the LINKMON process can initialize itself. Each subsequent
SERVERCLASS_SEND_ call in this processor causes the LINKMON process to
reattempt initialization; once the condition is corrected, the LINKMON process can
complete initialization.
Initialized and running
LINKMON cannot be run
SEGMENT_ALLOCATE_ error error-number [ (error detail
error-detail) ] on swap file swap-file-name