TS/MP System Management Manual (G06.24+, H06.03+)

Configuration Limits and Defaults
NonStop TS/MP System Management Manual—541819-001
C-3
Table C-2. Limits and Defaults for Parameters (page 1 of 10)
PATHCOM
Parameter* SPI Token/Field** Value Limits and Defaults
ARGLIST ZPWY-TKN-DEF-
SCARGLIST
Values: OSS process startup argument list;
from 2 to 24,000 characters.
ZPWY-TKN-DEF-SCENV +
ZPWY-TKN-DEF-SCARGLIST
cannot exceed 24,000 bytes.
Default: Empty argument list
ASSOCIATIVE ZASSOCIATIVE Values: ON | OFF
Default: OFF
AUTORESTART ZAUTORESTART Values: 0 through 32,767
Value should be greater than 0.
Default: 0
BACKUPCPU ZCPU
ZCPUPAIR
Values: 0 through 15
Value should be a processor that is
greater than plus or minus 1 from
the primary processor.
Default: Depends on command
COUNT N.A. Values: 0 through 65,536
Default: 1
CPU
CPUS
ZCPU
ZCPUPAIR
Values: For processor pairs, maximum of 16
pairs, 0 through 15.
Backup processor numbers need not
be unique.
For a sequence of single CPUs,
maximum of 16 CPUs, 0 through 15.
Each processor must be unique.
Default: Determined by the PATHMON
process (all available CPUs are
used).
CREATEDELAY ZCREATEDELAY Values: HRS | MINS | SECS
0 through 16,383 SECS, or
0 through 1092 MINS, or
0 through 18 HRS
The time set for this parameter may
be added to the response time for all
transactions; therefore, the value
should be small.
Default: 1 MINS
*PATHCOM is the interactive management interface.
**SPI is the DSM management programming interface.