ViewSys User's Guide

ViewSys Run Command Syntax
ViewSys User’s Guide—526358-002
3-3
DELAY Command
ON
indicates that the VIEWSYS data will be logged into a CSV file named CSVFILE on
the current volume/subvolume. You can open CSVFILE in Microsoft Excel on a
workstation. If CSVFILE already exists, it will be overwritten.
OFF
indicates that the VIEWSYS data will not be logged to a CSV file. OFF is the
default setting.
Example
VIEWSYS CSVFILE ON
DELAY Command
Use the DELAY command to specify the approximate time between displays. The
actual time between displays is the delay time plus the time spent performing the
sample. If you omit this command, the delay defaults to 3 seconds.
number-seconds
is in the range 0 though 32767.
Example
VIEWSYS DELAY 10
DISPLAY Command
Use the DISPLAY command to specify the initial display type. If you omit this
command, the default is to display all processors.
display-type is one of:
Note. The EOF for the CSVFILE increases during every ViewSys sample interval. Disk space
consideration is a must when using this parameter. This option is primarily intended for QA
purposes.
DELAY number-seconds
DISPLAY display-type ** FKEYS **
Entity Display Processor Display
CPUBUSY CPU0
CPUQUEUE CPU1
PAGEFAULT CPU2