Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

Installing VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-002
2-7
Installing the VHS and VHSCI Programs and the
VHS GUI Agent Facility
Installing the VHS and VHSCI Programs and
the VHS GUI Agent Facility
To install the VHS and VHSCI programs and the VHS GUI Agent facility, run the
INSTVHS routine and follow the directions as shown in Figure 2-2.
You can terminate the installation activity by pressing the BREAK key at any time
during the installation process. If the installation produces undesirable results, you can
purge the undesirable files and reexecute the installation procedure.
After a successful installation of the VHS and VHSCI programs and of the VHS GUI
Agent facility, INSTVHS redisplay its menu and you can continue with the installation of
the VHS Browser facility.
Before you install VHS and VHSCI and the VHS GUI Agent facility, review Table 2-3 on
page 2-8 for the parameters required. For more information about the GUI installation
parameters, see Section 8, The VHS GUI.
Figure 2-2. Using the Installation Program
Note. VHS must be stopped before you update the VHS and VHSCI programs. Also, all users
of the VHS GUI must exit this application. If VHS is not stopped, or if the VHS GUI applications
are still running, the installation fails.
Install VHS,
VHSCI, & VHS
GUI programs
& agent files
Use option 1 of
the INSTVHS
routine
Start
Use the
INSTALL
program
Partial
SYSGEN
Complete
INSTALL
Run INSTALL^
TEMPLATES
Macro
VST022.vsd