Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

Installing VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-002
2-10
Installing the VHS and VHSCI Programs and the
VHS GUI Agent Facility
15 PRIMARY-LOG-
MAX-EXTENTS
maximum-extents 16 Specifies the maximum
number of extents to be
created for the primary log
file. The value is an integer
in the range of 1 through
978.
16 VHS-INSPECT-
SAVEFILE
Inspect/eInspect-
savefile
$SYSTEM.
VHSDUMP.
SAVE0000
Specifies the name of the
Inspect/eInspect
1
saveabend files for VHS.
The form of this parameter
is $volume.subvolume.
fileprefixnnnn, where
fileprefix must be 4
consecutive alphabetic
characters and nnnn is
replaced with numbers.
17 VHS-PURGE-
SAVEFILE
purge-savefile-
flag
FALSE Specifies whether VHS
should add the “force it” (!)
option when VHS sends a
SAVE command to
Inspect/eInspect
1
. When
this option is set to TRUE,
Inspect/eInspect
purges
any savefile that existed
before with the same file
name. Valid parameter
values are TRUE or
FALSE.
18 VHS-GUI-MODE gui-mode-flag OFF Specifies whether the VHS
GUI will be used to reply to
prompts. If the parameter is
set to OFF, the VHS GUI
will not be able to reply to
application prompts. Valid
parameter values are ON
and OFF. See Section 8,
The VHS GUI for a more
complete description of this
parameter.
Table 2-3. VHS and VHSCI Installation Parameter Values (page 3 of 5)
No. Name Value Default Description
1
The eInspect debugger is supported only on systems running H-series RVUs.