Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

VHSCI Messages
Virtual Hometerm Subsystem (VHS) Manual—429311-002
G-15
Message Descriptions
VHS 20089
Cause. The REPEAT command acts upon the entire remainder of the command line,
and therefore can only appear once in any command line.
Recovery. To obtain multiple levels of iteration, use REPEAT commands within OBEY
files.
VHS 20090
Cause. The specified value is out of range.
Recovery. Specify a value within range.
VHS 20091
Cause. A REPEAT command was specified before the execution of this command.
Recovery. Do not specify the REPEAT command in conjunction with this command.
VHS 20092
Cause. Too many repeat commands were specified on long command lines.
Recovery. Put commands to be repeated in an OBEY file and repeat the execution of
the OBEY file.
VHS 20093
Cause. The HELP command was entered without any help subject.
Recovery. Either leave the HELP command out of the repeated command or issue the
HELP command without first issuing the REPEAT command.
The REPEAT command may only appear once per command line
name value must be from lower-bound to upper-bound
This command is not allowed when a repeat command has been
issued
Repeat command stack overflow, command not available
Menu Mode HELP cannot be used in a REPEATed command