Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

VHSCI Messages
Virtual Hometerm Subsystem (VHS) Manual—429311-002
G-18
Message Descriptions
VHS 20111
Cause. Too many object names were specified in a single command.
Recovery. Split the object names into two commands.
VHS 20112
Cause. This message informs the user that processing has been terminated because
the maximum number of errors set by the ALLOW command has been exceeded.
Recovery. Either correct the conditions that are causing the errors or increase the
number of allowable errors with the ALLOW command.
VHS 20113
Cause. This message informs the user that processing has been terminated because
the maximum number of warnings set by the ALLOW command has been exceeded.
Recovery. Either correct the conditions that are causing the warnings or increase the
number of allowable warnings with the ALLOW command.
VHS 20114
Cause. The ASSIGN/PARAM command or ASSIGN/PARAM message cannot be
processed because the allocated space was exceeded.
Recovery. Clear unneeded ASSIGNs/PARAMs by using the CLEAR command.
VHS 20116
Cause. The home terminal was unavailable.
Recovery. If the home terminal was specified in the RUN command, then specify a
different home terminal; otherwise, consult your system manager.
The size of the specified object names exceed the allocated
space
Maximum number of allowable errors exceeded
Maximum number of allowable warnings exceeded
ASSIGN/PARAM message exceeds allocated space
NEWPROCESS error 16: I/O error on home terminal