Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

Installing VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-002
2-12
VHS, VHSCI, and VHS GUI Agent Installation
Procedure
VHS, VHSCI, and VHS GUI Agent Installation Procedure
This subsection summarizes the VHS, VHSCI, and VHS GUI Agent facility installation.
To run the INSTVHS routine, enter this at the TACL prompt:
3> instvhs
or
3> run instvhs
27 REMOVE-EXTRA-
SPACES
remove-space-flag ON When set to ON, VHS
replaces an occurrence of
multiple spaces by only
one space in the display
message. Valid values are
ON and OFF.
28 ACCEPT-EXT-
ASCII-
CHARACTER
accept-ext-ascii-
flag
OFF Specifies if VHS will accept
or not characters with eight
bit ON like KANA and
KANJI characters. Valid
values are ON and OFF.
29 AUTOMATIC-
INSPECT-
PROCESSING
Automatic-
Inspect/eInspect-
processing-flag
ON Specifies VHS will
automatically handle
Inspect/eInspect
1
prompts.
Valid values are ON and
OFF. ON means VHS will
automatically handle
Inspect prompts.
30 BACKUP-
CREATION-
MESSAGE-DELAY
Delay-in-backup-
creation- message
5 Specifies, in minutes, the
delay between each
occurrence of the backup
creation failure message.
Valid values are 0 through
999.
31 OPEN-TABLE-
THRESHOLD
Open-table-
threshold
90 Specifies how full, in
percent, the opener table
must be before VHS will
generate the ZVHS-EVT-
TABLE-THRESHOLD EMS
event. Valid values are
from 0 to 100.
Note. The default VHS process name is $VHS. If this name is already being used, make sure
to change the VHS process name in the installation procedure (by changing parameter 5 in
Ta ble 2- 3 on page 2-8 or by editing the VHSSTART file).
Table 2-3. VHS and VHSCI Installation Parameter Values (page 5 of 5)
No. Name Value Default Description
1
The eInspect debugger is supported only on systems running H-series RVUs.