Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

Installing VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-002
2-14
Installing the VHS Browser in ViewPoint
The INSTVHS routine creates the VHS startup file with the name specified by the
VHS-STARTUP-FILE parameter.
When the above steps are completed successfully, the installation of the VHS and
VHSCI programs and the VHS GUI Agent facility is complete. You can continue
with the installation of the VHS Browser facility.
Installing the VHS Browser in ViewPoint
To install the VHS Browser facility into ViewPoint, run the INSTVHS routine and follow
the directions as shown in Figure 2-3.
Before you run INSTVHS, review Table 2-4 on page 2-15 for the parameters you must
provide during the installation.
Figure 2-3. Installing the VHS Browser in ViewPoint
Note. If you plan to install the VHS Browser facility in ViewPoint later, then you must be the
owner of ViewPoint and ViewPoint must be running on your terminal. For example, to install the
VHS Browser facility within ViewPoint, invoke ViewPoint by typing this at the TACL prompt:
2> viewpt
Browser
Install Browser in
ViewPoint
environment
Use option 2 of
the INSTVHS
routine
No
stand-alone?
VST023.vsd