Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

Installing VHS
Virtual Hometerm Subsystem (VHS) Manual—429311-002
2-35
VHS Parameters
VHS Conversational Interface Help and Error Text File
The VHSTEXT file contains help text and error messages for VHSCI. This file should
be located in the same subvolume as VHSCI. The VHSTEXT to be located on a
different subvolume from the VHSCI program, you can use an ASSIGN command to
tell VHSCI to read the VHSTEXT file from another subvolume.
VHS Parameters
Table 2-8 lists each parameter used by VHS and its default value if omitted.
1> ASSIGN VHSTEXT, $DEV.ZVHS.VHSTEXT
2>
3> == You may now run VHS and it will get VHSTEXT file
4> == from $DEV.ZVHS.VHSTEXT
Table 2-8. VHS Parameters (page 1 of 2)
Parameter Name Default Description
ACCEPT-EXT-
ASCII-
CHARACTER
OFF Specifies if VHS will accept non-ascii characters (e.g.
Kanji). The value can be ON or OFF.
AUTOMATIC-
INSPECT-
PROCESSING
ON Specifies if VHS will automatically process
Inspect/eInspect prompts
1
. The value can be ON or OFF.
BACKUP-
CREATION-DELAY
5 Delay in minutes between each occurrence of the backup
creation failure message. The value must be between 0
and 999.
ENVIRONMENT VHS Specifies the name of the environment that this VHS
process will run. This name has two purposes: a prefix for
all EMS messages generated, and for the VHS Browser
facility to specify, which VHS environment the user wants
to look at.
GENERATE-
DISPLAY-EVENT
ON Specifies if EMS events must be generated for display
type messages. The value can be ON or OFF. If the VHS-
GUI-MODE parameter is ON, GENERATE-DISPLAY-
EVENT will always be considered to be ON.
GENERATE-
INSPECT-EVENT
ON Specifies if EMS events must be generated for
Inspect/eInspect/Debug type messages
1
. The value can
be ON or OFF. If the VHS-GUI-MODE parameter is ON,
GENERATE-INSPECT-EVENT will always be considered
to be ON.
GENERATE-
PROMPT-EVENT
ON Specifies if EMS events must be generated for
prompt/reply type messages. The value can be ON or
OFF. If the VHS-GUI-MODE parameter is ON,
GENERATE-PROMPT-EVENT will always be considered
to be ON.
1
The eInspect debugger is supported only on systems running H-series RVUs.