Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

ManualsBrandsHP ManualsServerHP NonStop G-Series

Installing VHS

Virtual Hometerm Subsystem (VHS) Manual—429311-002

2-36

VHS Parameters

MAXEXTENTS 16 Specifies the maximum number of extents to be created

for the primary log file. The value is an integer in the

range of 0 through 978.

OPEN-TABLE-

THRESHOLD

90 Specifies the percentage of full value of the opener table,

at which VHS will generate an EMS event message. The

value must be between 0 and 100.

PRIMARY-

SECURITY

NUUU Specifies the default security used by VHS when it

creates primary log files.

PROMPT-EVENT-

RESEND-DELAY

15 Specifies the time (in minutes) VHS will wait before

generating a repeat (ZVHS-EVT-RESEND-PROMPT)

event for an unanswered prompt. This parameter will be

ignored if VHS-GUI-MODE is set to OFF. The possible

values are from 1 to 60. For more information, see

Section 8, The VHS GUI

PURGE-SAVEFILE FALSE Specifies whether VHS should add the “force it” (!) option

when VHS sends a SAVE command to Inspect. When this

option is set to TRUE, Inspect will purge any savefile that

existed before with the same file name. The valid

parameter values are TRUE or FALSE.

REMOVE-EXTRA-

SPACES

TRUE Specifies whether VHS deletes extra spaces (two or more

consecutive spaces) in displaying messages. By deleting

extra spaces, VHS makes the messages more readable

and prevents line truncations if messages exceed

displayable line length.

SUPPRESS-

DISPLAY

FALSE Specifies whether the display messages sent to VHS will

be shown on the ViewPoint or NonStop NET/MASTER

screen. The valid parameter values are TRUE or FALSE.

When the VHS-GUI-MODE parameter is ON, VHS

generates additional display events that are not affected

by this parameter. For more information, see Section 8,

The VHS GUI.

VHS-LOGGER ON Specifies if VHS must log in its primary log files. The

value can be ON or OFF.

VHS-GUI-MODE OFF Specifies whether the VHS GUI will be used to reply to

prompts. If the parameter is set to OFF, the VHS GUI will

not be able to reply to application prompts. Valid

parameter values are ON or OFF. For more information,

see Section 8, The VHS GUI

Table 2-8. VHS Parameters (page 2 of 2)

Parameter Name Default Description

The eInspect debugger is supported only on systems running H-series RVUs.