Virtual Hometerm Subsystem (VHS) Manual (G06.24+, H06.04+, J06.03+)

Using VHS

Virtual Hometerm Subsystem (VHS) Manual—429311-002

3-3

Guidelines for Running VHS

If you use the VHSSTART file to start VHS, you do not need to be concerned with

these run-time guidelines. However, if you run VHS from TACL, make sure you follow

these guidelines:

•

VHS must be run as a named process because it is opened by other processes

and has device subtype 30 (device emulation).

•

VHS should be run as a process pair because it must be always available to

receive messages.

•

To run VHS with High PIN support, ensure that the #HIGHPIN built-in variable is

set to On at the TACL prompt.

PARAM ENVIRONMENT-NAME "VHS"

ASSIGN PRIMARY-LOGFILE, $SYSTEM.VHSLOG.LOG, EXT (100, 100), CODE 0

PARAM PRIMARY-LOGFILE-BUFFERED OFF

PARAM PRIMARY-LOGFILE-PURGE ON

PARAM MAXEXTENTS 16

PARAM PRIMARY-SECURITY "NUUU"

PARAM SUPPRESS-DISPLAY FALSE

ASSIGN INSPECT-SAVEFILE, $SYSTEM.VHSDMP1.SAVE0000

PARAM PURGE-SAVEFILE FALSE

ASSIGN INSPECT-FILE, $SYSTEM.VHSDMP1.VHSINSP

PARAM VHS-LOGGER ON

PARAM ADD-TEXT-TO-EVENT ON

PARAM GENERATE-INSPECT-EVENT ON

PARAM GENERATE-PROMPT-EVENT ON

PARAM GENERATE-DISPLAY-EVENT ON

PARAM REMOVE-EXTRA-SPACES ON

PARAM ACCEPT-EXT-ASCII-CHARACTER OFF

PARAM VHS-GUI-MODE OFF

PARAM PROMPT-EVENT-RESEND-DELAY 15

PARAM AUTOMATIC-INSPECT-PROCESSING ON

PARAM BACKUP-CREATION-MESSAGE-DELAY 5

PARAM OPEN-TABLE-THRESHOLD 90

RUN $SYSTEM.VHS.VHS / NAME $VHS1, CPU 0, PRI 180, TERM $TRM0.#A, NOWAIT/ 1

== Second VHS process $VHS2

ASSIGN INSPECT-SAVEFILE, $SYSTEM.VHSDMP2.SAVE0000

ASSIGN INSPECT-FILE, $SYSTEM.VHSDMP2.VHSINSP

RUN $SYSTEM.VHS.VHS / NAME $VHS2, CPU 0, PRI 180, TERM $TRM0.#A, NOWAIT/ 1

== Third VHS process $VHS3

ASSIGN INSPECT-SAVEFILE, $SYSTEM.VHSDMP3.SAVE0000

ASSIGN INSPECT-FILE, $SYSTEM.VHSDMP3.VHSINSP

RUN $SYSTEM.VHS.VHS / NAME $VHS3, CPU 0, PRI 180, TERM $TRM0.#A, NOWAIT/ 1