Virtual TapeServer 6.03.41 Installation Guide

119
SCSI-to-Fibre Channel Adapter Upgrade
This appendix provides instructions to replace one or more SCSI cards with the same number
of VTS-supported 2Gb Fibre Channel (FC) cards on the VT5900-E.
Requires the View/Manage Configuration and Factory Setup Activities access rights
To replace SCSI cards with FC cards and reconfigure VTS
1. Switch all buses to Physical (Tape) mode and block startup.
a. On the VTS web interface, click Factory Setup on the navigation pane.
b. When prompted, enter the login credentials.
c. Click Factory Options and enter the login credentials again.
d. Click Manage system limits. The Manage system limits page is displayed.
e. Write down the current configuration. Note the following:
• Maroon boxes indicate buses cannot be set to Virtual (such as those on the 4Gb
Fibre Channel card)
• Grey boxes indicate buses on the SCSI card(s)
• Yellow boxes indicate buses on the 2Gb Fibre Channel card(s)
f. Select the Physical checkbox for all buses and then click Set Limits.
g. Click Supervisor Functions on the navigation pane.
h. Click Block TapeServer Startup on the Supervisory Functions page.