Virtual TapeServer 6.03.41 Installation Guide

SCSI-to-Fibre Channel Adapter Upgrade | 121
Here is a snapshot of the SCSI card after it is removed:
g. After you install the Fibre Channel upgrade cards in the appropriate slots, make sure
the blue clips are firmly seated and locked in place on each slot. Then, re-install the
PCI Riser cage in the DL385 G2 chassis. Once aligned, firmly press the module into
place. Re-tighten the two blue pull tabs on the PCI Riser cage.
h. Place the top cover back in place and secure it. Slide the HP DL385 G2 ProLiant
server back into the rack and secure the two quick-disconnect screws on the front
panel.
i. From the rear of the HP ProLiant DL385 G2 server, reconnect any remaining SCSI
cables to the same ports where they were originally connected, if necessary. Because
you removed one or more SCSI cards, you will have extra, unused SCSI cables.
Reconnect the power cords.
4. Restart VTS.
a. Power on the ProLiant server by pushing the power button on the front panel. The
restart process begins and is complete when the screen displays a login prompt.
b. Power on all of the SCSI converters using the switch on the rear of each unit.
Depending on how many SCSI cards were removed from the ProLiant server, some
converter ports or entire units may no longer be used.
5. Configure the remaining SCSI bus(es) with the original settings.
a. On the VTS web interface, click Factory Setup on the navigation pane.
b. When prompted, enter the login credentials.
c. Click Factory Options and enter the login credentials again.
d. Click Manage system limits. The Manage system limits page is displayed.
e. For the SCSI buses, set the buses to Virtual or Physical according to the settings that
were recorded in step
1e.
f. Click Set Limits.