Virtual TapeServer 6.03.41 Installation Guide

124 | Adding Virtual Tape Drives
c. Click Manage Tape Connections.
d. Click Add a new physical tape. The Add Physical Tape page is displayed.
e. From the bus drop-down list, select the value that is assigned to all other physical
tapes on VTS. In the example above, this value is 2.
f. From the target drop-down list, select the value above the target noted in step 1b. In
the example, the target value was 1 so you would select 2 here.
g. Leave the lun drop-down list set to 0.
h. Leave the initiator drop-down list set to 7.
i. In the name field, increment the number that is appended to the physical tape drive
noted in step
1c. In the example, the physical tape drive was named PTAPE01,
therefore you would enter PTAPE02 here.
j. Select RAID from the type drop-down list.
k. Click Add Physical Tape.
3. Add a new logical tape, as follows:
a. Click Setup Tapes at the bottom of the page to display the Manage Tape Connections
page.
b. Click Add a new logical tape. The Add A New Logical Tape page is displayed.
c. In the field in the new tape name column, increment the number that is appended to
the logical tape noted in step
1d. In the example, the logical tape was named
LTAPE01, therefore you would enter LTAPE02 here.
d. Select the physical tape created in step 2.
e. Click Add Logical Tape.