Virtual TapeServer 6.03.41 Installation Guide

126 | Adding Virtual Tape Drives
5. Add a new tape connection, as follows:
a. Click Setup Tapes at the bottom of the page to display the Manage Tape Connections
page.
b. Click Add a tape connection. The Add A Tape Connection page is displayed.
c. Select the new virtual tape from the Virtual Tapes section of the page.
d. Select the new logical and physical drives from the Logical Tapes section of the page.
e. Click Add Tape Connection. If successful, the connection is added at the bottom of
the virtual-logical-physical associations on the System Overview page.
It is recommended that you back up the VTS database after modifying the VTS configuration.
To back up the database, you must have the Factory Setup Activities right. Click Factory
Setup on the navigation pane, and then click Administrator Utilities. On the
Administrator Utilities page, click Backup The Database. Specify a location where the
backup file will be saved and click Proceed.