Virtual TapeServer 6.03.41 Installation Guide

Configuring EMS Communication | 63
ems_password_
NSserver
The password for the specified
user ID for the Telnet session.
After you set this parameter,
the value is displayed as ******
in the configuration file.
Password Yes
ems_notify_enable Enables EMS messages to be
generated for notifications.
YES or NO No
ems_notification_
enable
Enables VTS to send
notification messages back to
the NonStop host from EMS
messages.
YES or NO No
ems_notification_
level
Enables EMS to acknowledge
certain EMS messages and
generate completion status
(success or failure) messages.
This parameter is synonymous
with the ems_hsm_
backup_notification
parameter set for migration
configuration. Set this
parameter to one or more of the
values, separated by spaces. If
the notification level of the
event matches one of the words,
the event log message is
forwarded to the EMS host. If
you set this parameter to
NONE, no event log messages
are forwarded to the host.
ALL, INFO,
WARNING,
ERROR,
CRITICAL,
or NONE
No
ems_notify_
hostnames
Specifies the host systems that
VTS will notify. This parameter
defaults to the value of
ems_hostnames if it is not
specified in the configuration
file.
List of
hostnames
or IP
addresses
No
ems_notify_wait_
timeout
Specifies the number of seconds
to allow the host to process
commands before VTS expects
to prompt for another command.
Typically, this should be 2-3
seconds but it causes no harm to
allow more time for the host.
Integer No
Parameter Description Values Required