Virtual TapeServer 6.03.41 Installation Guide

64 | Configuring EMS Communication
ems_notify_logout_
timeout
Specifies the number of seconds
to wait after issuing the
LOGOUT command and before
closing the socket connection.
Integer No
ems_keep_alive Enables VTS to send periodic
EMS messages to the host so
that the Telnet session does not
time out. When enabled, EMS
filtering on the host can be
increased because VTS stays
alive.
YES or NO No
ems_response_time
or
ems_response_time_
NSserver
Specifies the timeout value (in
seconds) used to wait for each
response during the EMS Telnet
login process. Note that the
_NSserver suffix is optional
and, when omitted, this
parameter applies to all
processing (but is overridden by
_NSserver specifications).
Integer No
ems_hostport_
NSserver
Specifies the target Telnet port.
The default value is 23, which is
the default value on the
NonStop server.
You can specify _ANYSYS
instead of _NSserver.
Integer No
ems_service_
prompt_type
Specifies the service selection
prompt to which the EMS login
process responds and begins.
type is the hostname of the
NonStop server or
TYPE:choice, where choice is
the login service, such as TACL,
TACLS, XYGATE, or
SAFEGUARD. You can also
specify _ANYSYS instead of
_type.
Assign any search pattern as a
Perl regular expression, and the
special %username% and
%password% values may be
used in responses to equate to
those values. All entries should
be enclosed in single quotes
rather than double quotes.
Expression No
Parameter Description Values Required