Virtual TapeServer 6.03.41 Installation Guide

66 | Configuring EMS Communication
ems_login_
successful_type
Defines a command string to
send after successful login.
Specify this in accordance with
the syntax shown in
ems_service_prompt_type.
Expression
or null
No
ems_vaults_
NSserver
Restricts access to vaults from
any hosts.
ANYSYS is not valid here. This
list of permitted vaults should
be specified as a space-delimited
list. For any host, if there are no
vaults specified here then all
vaults are accessible. Leading
slashes in the vault list are
optional.
List of
vaults
No
ems_mount_delay Specifies the minimum number
of seconds that must elapse
after VTS receives a mount
request. The mount is queued
and the virtual tape is locked for
mounting or a restore by a
backup management
application (BMA).
Integer No
ems_InterSystem
Communication_
hosts
Specifies a list of hostnames or
IP addresses of other VTS
systems with which VTS will
coordinate mount processing.
This parameter is required only
if GFS or NFS is implemented.
It is primarily used to cancel
pending mounts on other VTS
systems that have simultaneous
access to the same vaults
mounted by NFS or GFS.
List of host
names or IP
addresses,
or null
No
Parameter Description Values Required