Virtual TapeServer 6.03.41 Installation Guide
Configuring EMS Communication | 67
Here is an example of the required parameters:
ems_enable='YES'
ems_hostnames='DEV2'
ems_hostaddr_DEV2='192.168.50.66'
ems_hostdevs_DEV2='$TAPE25'
ems_virtdevs_DEV2='VTAPE25'
ems_username_DEV2='super.user'
ems_password_DEV2='p@ssword'
ems_service_select_DEV2='TACL'
ems_login_command_DEV2='#SET #INFORMAT TACL |EMSDIST /CPU 0, PRI
100, NAME $VTMS1/ TYPE P, COLLECTOR $0, TEXTOUT [#MYTERM]'
Here is an example of the parameters set in the default VTS configuration file:
ems_enable="NO"
ems_mount_delay="0"
ems_notify_enable="NO"
ems_notification_enable="NO"
ems_notification_level="ERROR CRITICAL"
ems_keep_alive="YES"
ems_notify_hostnames=""
ems_notify_wait_timeout="20"
ems_notify_logout_timeout="3"
ems_InterSystemCommunication_hosts=""
ems_hostport_ANYSYS="23"
ems_response_timeout='5'
ems_service_prompt_ANYSYS='/^Enter Choice>\s*$/i'
ems_service_select_ANYSYS='TACL'
ems_login_userprompt_TYPE:TACL='/TACL 1>\s*$/'
ems_login_useranswer_TYPE:TACL='logon %username%'
ems_login_passprompt_TYPE:TACL='/Password:\s*$/i'
ems_resetdevs_
NSserver
Specifies the list of tape names
as known to the host system for
which we will issue a reset
before each mount. The
ems_mount_reset parameter
is a global override for this and
must be enabled for the
ems_resetdevs parameter to
take effect. You can also specify
ALL instead of a list of tapes. If
ANYSYS is specified for
NSserver, only ALL is
recognized.
List of tape
names or
ALL
No
Parameter Description Values Required