Virtual TapeServer 6.03.41 Operations and Administration Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series

76 | Using Scan/Cleanup

Defaults for these user-defined control parameters are as follows:

cleanup_enable='NO'

cleanup_show_NO='NO'

cleanup_scan_at='00:00'

cleanup_interval='24'

cleanup_autoerase='NO'

cleanup_nonMigrated='NO'

cleanup_minimum_size_GB='0'

cleanup_minimum_size_MB='0'

cleanup_show_erase_column='NO'

cleanup_threshold_percent='90'

cleanup_show_erase_control_files='NO'

cleanup_show_size_column='NO'

meta_control_panel='NO'

Here is a sample configuration:

cleanup_enable='YES'

cleanup_show_NO='NO'

cleanup_scan_at='00:00'

cleanup_interval='24'

cleanup_autoerase='NO'

cleanup_threshold_percent='90'

cleanup_nonMigrated='YES'

cleanup_show_erase_control_files='NO'

cleanup_show_NO Controls whether VTS should display the

NO rows on the Scan/Cleanup page. Many

of the virtual tapes will not be scheduled for

erasure. To make the display smaller and

simpler, the NO rows are suppressed. When

this parameter is set to NO, a small button

is shown that permits the user to

temporarily override this parameter and

show the NO rows.

YES or NO

cleanup_show_erase_

column

Shows or hides the Erase meta data column

in the Status Table. The date of the last

erasure may not be important to a

particular installation of VTS. However,

this information may easily be viewed by

enabling this feature.

YES or NO

cleanup_show_size_

column

Shows or hides the Size column in the

Status Table.

YES or NO

meta_control_panel Shows or hides the Meta Data Control

Panel, which enables you to read and write

metadata on the virtual tape. Set this

parameter only if diagnosing problems or

instructed to do so by Support.

YES or NO

Parameter Description Values