Virtual TapeServer 6.03.41 Operations and Administration Guide

87
Using Instant DR
Instant DR is an advanced software module (VT5907 or VT5907-A) that enables you to create
and maintain identical copies of backup data on Virtual TapeServer (VTS) disk storage at one
or more locations. In the event of a disaster, remote recovery operations can begin
immediately using the backup data copy on a remote VTS server.
Instant DR is designed to transmit data from one site to another over a wide area network
(WAN). Virtual tapes are transmitted from one vault to another. The Instant DR jobs indicate
the pools or virtual tapes to be transmitted. When a job is initiated, a copy of the virtual tape
is transmitted over the network link. Be aware that the virtual tapes duplicated on a remote
vault consume additional disk space, which is the same amount as the original virtual tape.
VTS servers cannot “see” each others’ pools and virtual tapes until the Instant DR jobs run.
The pools and virtual tapes in the primary operation page look identical if all virtual tapes are
copied. If selected virtual tapes are copied using the Instant DR job, the virtual tape and pool
lists are different. Automatic Event Management Service (EMS) mounting chooses from pools
as it would in day-to-day operations because the virtual tapes will be created in the new vault.
If Instant DR is licensed, you can create new Instant DR backup schemes as well as launch
and monitor the remote synchronization processes. You can also automate Instant DR
backups using the VTSPolicy command, if EMS communication is configured (see
Configuring
EMS Communication on page 19). This chapter describes how to perform these tasks.