Virtual TapeServer 6.03.42 Installation Guide

94 | Enabling Enterprise Integration and Migration
Configuring migration
Be sure that the BMA client is installed and configured on the VTS server. Refer to the BMA
product documentation for more information. Then, modify the VTS configuration file to
configure migration, which entails configuring the hsm_ parameters as defined below.
Note A default configuration file is defined for each VTS server. To override the default
settings, you must define settings as described below. Technically, you do not edit the
VTS configuration file; you simply define parameters that override those set in the
configuration file.
Requires the Edit VTS Configuration File access right
To modify the VTS configuration file to configure migration
1. Click Supervisor Functions on the navigation pane of the VTS interface.
2. Click Edit VTS Configuration File.
3. Add the following parameters at the bottom of the file that is displayed:
Parameter Description Values Req’d?
hsm_enable Enables migration.
Default value: YES
YES or NO Yes
hsm_product Identifies the BMA:
• BEX for Backup Express
• NBP for NetBackup
• TSM for Tivoli Storage Manager
• LEG for Networker
For automated migration, you can
specify any of these values, which
depends on the BMA. For manual
migration, you must specify TSM.
Default value: TSM
BEX, NBP,
TSM, or LEG
Yes
hsm_server For Backup Express, NetBackup,
and Networker only:
Specifies the BMA server hostname.
Hostname Yes
hsm_pool For Networker only:
Specifies the pool name.
Pool name Yes
hsm_username For Backup Express and NetBackup
only:
Specifies the username to log in to
the BMA.
Username Yes
hsm_password For Backup Express and NetBackup
only:
Specifies the password to log in to
the BMA.
Password Yes