Virtual TapeServer 6.03.42 Installation Guide

122 | SCSI-to-Fibre Channel Adapter Upgrade
2. Unmount all vaults, stop the PMF on the NonStop server, and shut down VTS.
a. From a terminal window on VTS, log in as root.
b. Use the umount /VAULTxx command (where xx is the vault number) to unmount all
vaults. Repeat this command for each vault on the system until all vaults are
unmounted.
c. Verify that all vaults are unmounted by typing mount in the VTS terminal window.
There should be no vaults mounted.
d. From the terminal window on VTS, open the /etc/fstab file. Use a text editor to
comment out all vaults in the /etc/fstab file by placing a # symbol before each
LABEL=/VAULT line (for example, #LABEL=/VAULT01). Repeat until all vaults are
commented out.
e. Save all changes and exit the editor.
f. From the NonStop server, stop all virtual tape drives using the SCF STOP PMFname
command.
g. Power down all VTS SCSI converters using the switch on the rear of each unit.
h. From a terminal window on VTS, enter shutdown now.
3. On the HP ProLiant DL585 (VT5900-A)
Remove the SCSI card(s) and install the Fibre Channel card(s).
a. From the rear of the HP ProLiant DL585 server, mark each SCSI cable with the port
position to which it is attached. This will make it easier to reattach them to the correct
SCSI ports later.
b. Disconnect the ProLiant power cords as a precaution. Disconnect all SCSI cables from
the SCSI adapters for easier access to the adapter cards.
c. If the HP ProLiant DL585 is mounted in a rack, loosen the front pull tabs and slide
the server out so that you can open the top cover. Do not remove the server from the
rails. If there is a stabilizer foot, extend it so the enclosure does not tip forward.
d. Open the ProLiant DL585 top cover, remove it, and set it aside.
e. Look inside the ProLiant DL585 server to the back where the SCSI and Fibre
adapters are located. You will see a shipping bracket secured with a quick-disconnect
pull tab that you need to release to remove the shipping bracket. Once the shipping
bracket is removed, you can access the blue tabs that lock and unlock the SCSI and
Fibre Channel cards.