Virtual TapeServer 6.03.42 Installation Guide

142 | Hardware Information for Legacy Installations
6. Remove SCSI cards from the server as follows:
Note This order must be followed or the upgrade will not work. Every HP ProLiant
DL585 server has SCSI and Fibre Channel cards in the same physical slots. A
Fibre Channel card is always in slots 5 and 6. You will see slot numbers on the
chassis above each slot. These numbers are visible on the inside and outside of the
chassis.
The following order of SCSI card removal must be followed:
a. Remove the SCSI card in slot 3 and install the first Fibre Channel card in slot 3.
b. Remove the SCSI card in slot 4 and install the second Fibre Channel card in slot 4, if
necessary.
c. Remove the SCSI card in slot 2 and install the third Fibre Channel card in slot 2, if
necessary.
d. Remove the SCSI card in slot 1 and install the fourth Fibre Channel card in slot 1, if
necessary.