Virtual TapeServer 6.03.42 Installation Guide

Hardware Information for Legacy Installations | 143
e. Remove the SCSI card in slot 7 and install the fifth Fibre Channel card in slot 7, if
necessary.
f. Remove the SCSI card in slot 8 and install the sixth Fibre Channel card in slot 8, if
necessary.
Here is a snapshot of the SCSI card after it is removed:
7. After you install all of the Fibre Channel upgrade cards in the appropriate slots, make
sure the blue clips are firmly seated and locked in place on each slot. Then, re-install the
shipping bracket and make sure the pull tab is secure.
8. Place the top cover back in place and secure it. Slide the HP DL585 ProLiant server back
into the rack and secure the two quick-disconnect screws on the front panel.
9. From the rear of the HP ProLiant DL585 server, reconnect any remaining SCSI cables to
the same ports where they were originally connected, if necessary. Because you removed
one or more SCSI cards, you will have several extra, unused SCSI cables. Reconnect the
power cords.
Now, continue with step 5 on page 125 and step 6 on page page 125.
On the HP ProLiant DL380 G4 (VT5900-B and VT5900-C)
After completing step 2 on page 122, remove the SCSI card(s) and install the Fibre Channel
card(s), as follows:
1. From the rear of the HP ProLiant DL380 server, mark each SCSI cable with the port
position to which it is attached. This will make it easier to reattach them to the correct
SCSI ports later.
2. Disconnect the ProLiant power cords as a precaution. Disconnect all SCSI cables from the
SCSI adapters for easier access to the adapter cards.
3. If the HP ProLiant DL380 is mounted in a rack, loosen the front pull tabs and slide the
server out so that you can open the top cover. Do not remove the server from the rails. If
there is a stabilizer foot, extend it so the enclosure does not tip forward.
4. Open the ProLiant DL380 top cover, remove it, and set it aside.