Virtual TapeServer 6.03.42 Installation Guide

Hardware Information for Legacy Installations | 145
The following order of SCSI card removal must be followed:
a. Remove the SCSI card in slot 3 and install the first Fibre Channel card in slot 3.
b. Remove the SCSI card in slot 2 and install the second Fibre Channel card in slot 2, if
necessary.
Here is a snapshot of the SCSI card after it is removed:
7. After you install all of the Fibre Channel upgrade cards in the appropriate slots, make
sure the blue clips are firmly seated and locked in place on each slot. Then, re-install the
PCI Riser cage in the DL380 chassis. Once aligned, firmly press the module into place. Re-
tighten the two blue pull tabs on the PCI Riser cage.
8. Place the top cover back in place and secure it. Slide the HP DL380 ProLiant server back
into the rack and secure the two quick-disconnect screws on the front panel.
9. From the rear of the HP ProLiant DL380 server, reconnect any remaining SCSI cables to
the same ports where they were originally connected, if necessary. Because you removed
one or more SCSI cards, you will have extra, unused SCSI cables. Reconnect the power
cords.
Now, continue with step 5 on page 125 and step 6 on page page 125.
For step 7e on page 126, consider the following slot-to-bus relationships on the HP ProLiant
DL380 G4 (VT5900-B and VT5900-C):
PCI-X Slot Bus Number Virtual Tape Name
3 A 0 $VTAPE00
3 B 1 $VTAPE01
2 A 2 $VTAPE02
2 B 3 $VTAPE03
1 A 4 Fibre *
1 B 5 Fibre *