Virtual TapeServer 6.03.42 Installation Guide

16 | Installation Summary and Checklist
Cables
The following is a list of HP cables and their part numbers, which are provided by HP for VTS
installations.
Cable Part Number
S-series SCSI cable, 3 m (10 ft) 518-010W
S-series SCSI cable, 7.6 m (25 ft) 518-025W
S-series SCSI cable, 15.2 m (50 ft) 518-050W
S-series SCSI cable, 22.9 m (75 ft) 518-075W
LC-LC, Multimode Fibre cable, 2 m M8900-02
LC-LC, Multimode Fibre cable, 5 m M8900-05
LC-LC, Multimode Fibre cable, 15 m M8900-15
LC-LC, Multimode Fibre cable, 40 m M8900-40
LC-LC, Multimode Fibre cable, 80 m M8900-80
Note These cables are provided if listed in the CPSA description for the PID.
Fibre Channel upgrade card
To replace a SCSI card with a Fibre Channel (FC) card on a ProLiant server, you can
purchase the VT5900-FCU:
This FC upgrade card is a 2Gb/sec, dual-port, PCI-X-to-Fibre Channel host bus adapter
(HBA). See
SCSI-to-Fibre Channel Adapter Upgrade on page 121 for instructions on how to
install the card.
Upgraded installations
For VTS installations that are upgrading from 6.03.39 or later, refer to Hardware Information
for Legacy Installations on page 133 for an overview of the hardware and configuration
information supported in previous versions of VTS.